BlueCarve CNC Plasma Instructions
Set up your Spark Plasma CNC
Open-loop and closed-loop machines are set up the same way. Only the motor plugs differ: green connectors on open loop, plugs keyed by colour and type on closed loop. Every guide opens as a web page and can be printed or saved as a PDF.
Which Spark Plasma do you have?
Answer two quick questions and we'll list the guides and the MyPlasm config for your machine.
Safe operating procedure
Read this before you switch on.
Assemble your Spark Plasma
The legs and water tray guide is only needed if you bought them.
Set up MyPlasm CNC and get moving
Four short steps: install, load your config, set soft limits, first cut.
aInstall MyPlasm CNC
bLoad the config for your rack
Bought before February 2026
Straight rack, gear ratio 50.25. Every Landscape (1.5 x 1.0) machine also uses straight rack.
Bought February 2026 or later
Helical rack, ratio 66.7 (except Landscape machines).
- Click the cog in the top right of the MyPlasm main page, then the Software tab.
- Click Load Configuration, select the .zip you downloaded and click Open. Don’t unzip it.
cSet the soft limits for your size
On the Machine tab, set Axis Soft Limits:
| Size | X | Y | Z |
|---|---|---|---|
| 1.5 x 1.0 | 1270 | 770 | 150 |
| 1.5 x 1.5 | 1270 | 1270 | 150 |
| 1.5 x 3.0 | 1270 | 2770 | 150 |
| 1.8 x 3.3 | 1570 | 3070 | 150 |
dYour first cut
Troubleshooting
Keep this handy for your first cuts.
Manuals
Get to know MyPlasm and your plasma cutter. Thermacut cutters: follow the manual supplied with your cutter, including its air supply and cut chart.
Need help? Email adam@bluecarve.com.au with your machine size and a photo.
CNC router instructionsStuck on something? I’m Bingo. Answer a couple of questions and I’ll point you to the fix.
